I am having trouble fitting my rubber hatch on my kayak. What do I do?
I am having trouble fitting my rubber hatch on my kayak. What do I do?
Sometimes the rubber hatches are a bit difficult to put on the hatch rim. The fit is tight so that if forms a good seal to prevent water from entering the kayak.
The best way is to:
Start on one side pushing hatch down and running your hand along the rim
Continue to push and apply even pressure working your around the rim to the far side
Make sure the rubber hatch is seated flat against rim as you go.
If this is still giving you trouble, try applying a silicon spray to the hatch rim as a lubricant.
Replacing your hard plastic hatch rim on your kayak is relatively easy. You will need a multi-head screwdriver, a sharp knife and some good quality silicon. Please see attached instructions on a step by step guide to removing old rim and replacing it ...
We’ve put a lot of time and thought into providing you with a quality craft and we stand behind our product 100%. By reading your kayak’s warranty agreement and following these few simple maintenance steps, you should have years of problem-free fun ...
Hello, you can find the hatch covers for Riot Kayaks here: Large oval cover: https://boutiqueborealdesign.com/products/dual-density-hatch-w-bungee Small round cover: https://boutiqueborealdesign.com/products/dual-density-hatch-w-bungee-for-brittany ...
1. If the leak in your rim is small then try the following first with some silicon: Tear off the removable glue/silicon of the hatch rim where it is leaking as best you can by hand. Apply one full circle of glue to the hatch rim and screw parts, and ...
Hello, Rubber hatches for the Riot Kayaks can purchased here: Large oval hatches (stern and sometimes bow hatch): https://boutiqueborealdesign.com/products/dual-density-hatch-w-bungee S Small round hatches (usually the bow) : ...