How to fix bulkheads on thermoformed ABS kayaks
If you are experiencing the issue of the bulkhead becoming separated or unglued on your Thermoformed ABS kayak, there is a relatively easy fix following these steps and with white Sikaflex marine caulking. The following article explains the steps, tools and materials needed to fix a bulkhead that has separated from the hull or deck and needs re-gluing.
Tools and Materials Needed:
- clean rags or paper towel
- caulking gun
- shop vac (optional)
- 200 grit sand paper
- industrial rubbing alcohol
- paint scraper
- Marine sikaflex caulking (can be purchased on Amazon or most hardware stores)
Step 1: Spray industrial alcohol on the bulkhead white glue seam and wait 3 5 minutes to soften the white glue
Step 2: Use a paint scraper to clean up the softened white glue and clean the glue scum with a vacuum cleaner or rag
Step 3: .Use 200 grit sandpaper to sand the parts between bulkhead board and the hull that need to be glued. This will help increase the viscosity of the glue. Be careful not to sand the hull too much which will make hull looks rough . Clean up the residual glue and debris with a vacuum cleaner or rag.
Step 4: After determining the position of the bulkhead board, inject the glue (Sikaflex) on the gap between the bulkhead board and the hull. Make sure the glue fills
the full gap. Then clean up the excess glue and wait for 30 60 minutes. When the glue is still drying, ensure that the hull is kept dry and in well ventilated place.
See, download and print these instructions in PDF below.
Related Articles
How to repair or fix a cracked kayak
There is no reason why you cannot fix a plastic ABS Thermoformed or Composite boat on your own. Using these resources and the right tools it can be done. If it seems too difficult, then many kayak dealers and also marinas offer this service. Ask ...How do I fix or re-seal a foam kayak bulkhead?
Due to the flexing of the kayak both in transport and on the water, over time the foam wall separating the cockpit from the dry compartments (better known as a bulkhead) may come loose. The following video will show you how to inspect, prepare, fix ...How to restore finish and colour to an ABS thermoformed plastic kayak
It is relatively simple to restore the finish to an ABS thermoformed kayak with the right acrylic lacquer spraypaint and a few simple tools/ materials needed. Download the following article for step by step instructions on how to restore the surface ...How to replace the hull support / water bottle holder on a Riot / BorealDesign thermoformed ABS kayak
Here are the necessary things to replace a broken support / bottle holder on a thermoformed ABS kayak. Materials and Tools: a sharp utility knife small prybar sand paper gloves glue - we suggest a high quality plastic/metal adhesive which can be ...How do I repair and glue the window back in place on the Riot Intrigue?
The material of the window is plexiglass and the size is 1220*2440*4mm (if needed to replace it) To seal it you can use the glass glue to seal the window.: Glass Glue, Adhesive for Acrylic, for bonding Between Glass, Acrylic and Other Material Such ...