I have an older Edge 14.5 with a broken / bent rudder bracket. What can I do to fix this?

If the threads on the inside of the kayak are not stripped (then simply need to get you the two bolts and the bracket again)
https://boutiqueborealdesign.com/collections/skeg-rudder/products/c-bracket-rudder-support-w-hardware?variant=43089501225218

If the threads are stripped then we would need to ask the factory what the fix solution is. 

Let us know if this helps or you need more assistance. 

• Related Articles

• How to repair or fix a cracked kayak

  There is no reason why you cannot fix a plastic ABS Thermoformed or Composite boat on your own. Using these resources and the right tools it can be done. If it seems too difficult, then many kayak dealers and also marinas offer this service. Ask ...

• How to adjust the rudder support when it is crooked

  In this brief article we show you how to re-align a mis-aligned or slightly crooked rudder bracket / rudder mount. You can also download this as a document (see link at bottom of page) to print out and refer to as well below.

• My rudder on my Pedal Kayak is very hard to pull up and down. What can I do about this?

  For a sticky rudder issue, when the uphaul and downhaul rope is very hard to pull, the best fix is to replace rope with smaller diameter rope such as 3mm or 4mm nylon rope. Hope that helps,

• How do I fix or re-seal a foam kayak bulkhead?

  Due to the flexing of the kayak both in transport and on the water, over time the foam wall separating the cockpit from the dry compartments (better known as a bulkhead) may come loose. The following video will show you how to inspect, prepare, fix ...

• How to install the rudder on a Riot Kayaks Polarity 16.5 tandem kayak

  The installation of the rudder on a Riot Polarity 16.5 tandem kayak is pretty straight forward following these steps and by watching the video below. Tools: Star head screwdriver (or star head bit for your drill) Small pliers or wrench for tightening ...